C0596
Brake Booster Motor A Current Sensor Circuit Range/Performance
C0596 questions the current measurement of booster motor A itself rather than the motor. GM's 2016/2019 hybrid booster tests its overcurrent comparator at start-up by forcing minimum and maximum PWM and reading the comparator output back over a feedback line, while the voltage behind the master switch must sit near zero or near battery voltage; a hardware overcurrent flag on that line during operation also sets it (30 ms). GM's 2019 IBC unit injects zero, positive, negative and common-mode offsets into the current sense path at power-up, with the motor almost still and 7.1–18 V supply, and compares the results with their allowed bands. All Type A with MIL. Driver chips such as TI's DRV8343-Q1 short the amplifier inputs on command for this zero calibration.
Possible causes
- Faulty current sense amplifier or motor driver chip high
- Overcurrent comparator or its feedback line not responding medium
- Supply voltage outside the test window during start-up low
Symptoms
- Brake assist warning right after switching on
- Heavy brake pedal, check engine lamp on
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C0596
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.