C0593
Brake Booster Motor B Phase U-V-W Current Low
C0593 is meant for a current value on booster side B that is too low or negative where the controller expects about zero or a commanded positive current. It is not documented by any manufacturer; like C0592 it shows up only in GM's old keyword list PIP5094 with a different meaning. Unlike the high fault, a low value rarely reflects real current: more often the measuring chain has an offset. TI's DRV8343-Q1 has a calibration input that shorts the amplifier inputs internally so the controller can store the zero point and subtract it, and a drifted zero leads exactly to such readings. GM's matching test for side A trips below −20 A or −38 A. In a dual-winding motor like the Hyundai Mobis design, module B is then shut down and module A carries the load alone.
Possible causes
- Zero point of the side B current measurement drifted medium
- Defective power module B or its driver chip medium
- High resistance in a side B phase connection low
Symptoms
- Brake assist warning message
- Assist weaker under hard braking if only side A remains
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for C0593
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.