OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0590

Brake Booster Motor A Phase U-V-W Current High

C0590 means the current measured in the drive of booster motor A is too high, mostly checked while the bridge is idle and almost nothing should flow. GM uses it in several units, always Type A with MIL: its 2016/2019 hybrid booster trips on leakage current above 20 A for 5 ms, the XT4 module on an idle offset above 36.1 A or a phase current above 200 A, and the 2023/2025 EBCM tables on a shunt offset above 38 A for 0.2 s. In GM's 2019 IBC unit it also flags a bridge driver whose overcurrent detection fails its power-up self-test. Mitsubishi maps C18E1-19 of the Outlander PHEV brake unit to C0590 with MIL after one trip; booster assist, regeneration and automatic braking stop. On the 2011 Saab 9-5 the number was a damper actuator code.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 90

Possible causes

  • Leaking or partly conducting MOSFET in the booster motor bridge high
  • Shunt or measuring amplifier offset drifted upward medium
  • Winding short in booster motor A drawing excess current medium
  • Bridge driver chip failing its overcurrent self-test low

Symptoms

  • Brake assist warning, much higher pedal effort
  • Check engine, ABS or brake warning lamps on
  • Regenerative braking and automatic brake functions unavailable

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for C0590

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication