OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C058C

Brake Booster Motor B Position Sensor Circuit Low

C058C applies when the motor B position signal sits below its lower limit – usually a sensor line shorted to ground, a missing sensor supply or a damaged sensor element. No manufacturer publishes this code; GM limits its documented position checks to motor A, where C0588 trips in the XT4 module below 1,300 counts. The physics are the same on either side: Hitachi's resolver patent attributes a reading near 0 V to a ground short, and a vector-length check like the one Infineon specifies for its TLE5009 sine/cosine sensor exposes an amplitude that has collapsed. In a dual-winding booster as described by Hyundai Mobis, the inverter for winding B depends on this angle, so the module shuts that inverter down and relies on the remaining channel.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 8C

Possible causes

  • Signal line of sensor B shorted to ground high
  • Supply of sensor B missing or too low medium
  • Sensor element B or its magnet degraded, signal amplitude too small low

Symptoms

  • Brake warning lamp
  • Assist may continue on one channel with reduced dynamics

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C058C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication