OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C058B

Brake Booster Motor B Position Sensor Circuit/Open

C058B reports an open circuit at the position sensor of booster motor B. Such a second sensor exists where the booster has a second motor or winding system with its own commutation, or where the rotor angle is measured twice for safety. Stellantis shows that the eBooster of the Jeep Wagoneer has a motor B position channel, since its parts bulletin names C058E (range/performance) for it; C058B itself is not published by any maker. Kollmorgen's early patent on redundant windings gives every winding set its own group of Hall sensors, so losing one group only affects that set. An open line is detected as in Hitachi's resolver circuit: the bias signal no longer arrives and the input floats to its pull-up level. The module then drops channel B and runs on A or with reduced assist.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 8B

Possible causes

  • Broken signal or supply wire of position sensor B high
  • Loose or corroded contact in the sensor B connector medium
  • Failed sensor element B inside the booster low

Symptoms

  • Brake system warning with service message
  • Possibly reduced assist or limited assistance functions

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C058B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication