C0589
Brake Booster Motor A Position Sensor Circuit High
C0589 is the high counterpart: a sine or cosine line of motor A's position sensor reads above its permitted maximum. In GM's 2019 XT4 brake module a raw value above 2,795 counts, or a sum above 4,327, for 10 ms sets it; the 2023 and 2025 EBCM tables trip on a cosine reading above 4,075 counts lasting 0.15 s, a sine input above 2.252 V, or a calculated vector length above 1.14. GM classifies it as Type A, MIL on the first trip. Typical causes are a sensor line touching supply voltage or a broken sensor ground. Hitachi describes how a short to battery drives the evaluated signal to its upper limit, after which motor current is cut. Without a trustworthy rotor angle the booster cannot commutate its motor, so electric assist is withdrawn.
Possible causes
- Sensor signal line shorted to the sensor supply or battery voltage high
- Open sensor ground lifting the signals to the upper limit medium
- Internal sensor fault in the booster unit low
Symptoms
- Brake assist warning with check engine lamp (GM)
- Hard pedal, assist withdrawn
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0589
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.