OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0580

Brake Booster Motor A Phase U-V-W Circuit Low

C0580 flags a phase of booster motor A that is pulled too low, or a driver stage that cannot lift it properly. GM's 2016 and 2019 hybrid tables use it when the gate-drive supply of the bridge driver falls too far below the motor supply (7 V limit, 5 ms). In the 2019 IBC unit it covers a phase that does not drop under 0.99 V while its lower transistor conducts, a phase already near 0 V before the bridge is enabled, and an undercharged bootstrap capacitor – all Type A with MIL. Automotive gate drivers such as TI's DRV8305-Q1 report this charge-pump undervoltage themselves. Note the older meaning: on the 2011 Saab 9-5 and related GM cars, C0580 was the right front damper actuator of the adaptive suspension. In the booster meaning the module normally switches assist off.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 80

Possible causes

  • Phase lead of motor A chafed through and shorted to ground medium
  • Gate-driver or charge-pump supply in the brake module too low (internal defect or weak supply) high
  • Lower bridge transistor shorted or permanently driven medium

Symptoms

  • Electric brake assist off, pedal feels hard
  • Brake and stability warning lamps, on GM also the check engine lamp
  • Fault may appear right after switching the ignition on

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0580

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication