C0579
Brake Booster Temperature Sensor B Circuit Low
Electromechanical brake boosters watch the heat in their motor and power electronics so they can scale back assist before damage; a Hitachi Astemo patent, for example, describes one sensor on the motor and one in the drive circuit, with assist limited above set temperatures. GM reads two temperature channels from its booster: A under P25C6/P25C7, B under C0579/C057A. C0579 means channel B reads too low, which GM treats as a short to ground: under 0.03 V on five consecutive checks within 0.6 s in the 2023 and 2025 tables, Type B with MIL after two trips. GM's 2019 Cadillac XT4 tables use the same voltage with two detections between about 7 and 124 mph, but as Type C without MIL. The booster then runs a protective strategy.
Possible causes
- Temperature signal B shorted to ground inside the booster or its harness high
- Thermistor shorted, e.g. after overheating medium
- Fault in the booster control electronics reading the channel low
Symptoms
- Check engine light after two trips (GM 2023/2025), brake warning
- Brake assist may be reduced as a precaution
- Booster temperature B shows an implausible value on the scan tool
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0579
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.