OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0578

Brake Pressure Sensor D Circuit Range/Performance

For sensor D the range/performance check targets a signal that is electrically fine but implausible. In GM's 2016–2019 hybrid brake modules, where D measures left rear brake pressure, the zero offset is learned while the car is being driven above about 4.5 mph with the brake released and the hydraulic pump idle; an offset beyond ±1,500 kPa sets C0578 at once, Type A with MIL. To prove the repair GM asks for driving at roughly 37 mph for at least 5 s. Wheel pressure sensors can also be checked against each other when valves connect them to one common pressure, a method described in a Lucas/ZF patent that singles out the drifting sensor and its error. Likely causes are sensor drift, trapped pressure in the rear circuit or a ground offset.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 78

Possible causes

  • Zero point of sensor D drifted high
  • Pressure trapped in the rear circuit, e.g. sticking caliper or valve medium
  • Ground offset between sensor and brake module low

Symptoms

  • Check engine light and brake warnings (GM hybrids)
  • Rear brake pressure shown although no brake is applied
  • Code sets again after a short drive

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0578

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication