OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0577

Brake Pressure Sensor D Circuit/Open

C0577 stands for an open circuit of brake pressure sensor D. No manufacturer documents this code publicly. GM, which assigns sensor D to the left rear wheel pressure sensor in its hybrid brake modules, uses only C0575, C0576 and C0578 there; C0577 also appears in GM's code list for 2014 and older vehicles (PIP5094), where it belongs to GM's earlier numbering. An open wire is recognised because the reading moves into a band reserved for faults: if the module input has a pull-up resistor it goes high, with a pull-down it goes low, as Honeywell specifies for its ratiometric transducers. Brake-by-wire units monitor each extra pressure sensor separately; Bosch's EBS, for example, flags caliper and axle sensor faults one by one.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 77

Possible causes

  • Connector of sensor D unplugged, corroded or with a spread terminal high
  • Wire broken near the sensor, e.g. at a flex point toward the rear axle medium
  • Internal open circuit in sensor D low

Symptoms

  • Brake, ABS or stability warning lamp
  • No valid value for sensor D on the scan tool
  • Regenerative braking or brake assist limited

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0577

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication