C0576
Brake Pressure Sensor D Circuit High
C0576 is set when the signal of brake pressure sensor D sits too high. GM's 2016–2019 hybrid brake tables, where D is the left rear wheel pressure sensor, compare the signal line against the supply: a level over 3.3 V lasting 0.1 s at ignition on stores the code, Type A with MIL after one trip. A short to the 5 V reference or to battery voltage and a broken sensor ground are the usual reasons; an internally damaged sensor can also report full scale. A Bosch trainer describes such a sensor as 5 V supplied, giving under 1 V with the brakes released and rising with pressure, which makes a high reading at rest easy to spot on live data. The module then no longer trusts the value, and regenerative blending and ABS/ESC are restricted.
Possible causes
- Signal line shorted to the 5 V reference or to battery voltage high
- Open sensor ground, signal floats high medium
- Sensor internally damaged, reports maximum pressure medium
Symptoms
- Check engine light and brake warnings (GM hybrids)
- High rear pressure shown with the pedal released
- Less regenerative braking, ABS/ESC restricted
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0576
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.