OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0575

Brake Pressure Sensor D Circuit Low

Brake pressure sensor D is a further hydraulic pressure sensor whose position is set by the manufacturer. In GM's hybrid brake control modules of 2016–2019 it measures brake pressure at the left rear wheel, and C0575 is stored when its signal stays under 0.3 V for 0.1 s while the ignition is on, rated Type A with MIL after one trip. Without that value the module lacks the rear wheel pressure it uses to blend regenerative and friction braking. Older GM vehicles used the same number for something unrelated: the left front damper actuator circuit of the electronic suspension (Saab 9-5, and GM full-size trucks whose engine harness chafed on the vacuum pump pulley, PIT5307G). Typical causes are a short to ground, lost sensor supply or a failed sensor.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 75

Possible causes

  • Signal line of sensor D shorted to ground high
  • Sensor supply interrupted, output drops to near 0 V medium
  • Defective pressure sensor medium

Symptoms

  • Check engine light with brake or stability warning (GM hybrids)
  • Regenerative braking reduced, more friction braking
  • Rear pressure reading near zero even when braking

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0575

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication