C0573
Brake Pressure Sensor C Circuit/Open
C0573 is reserved for an interrupted circuit of brake pressure sensor C – a broken signal, supply or ground wire, or a connector that has lost contact. No manufacturer documents it publicly; GM, which uses C0571 and C0572 for this sensor, books an open signal line under C0572. How an open shows up depends on the input circuit: with a pull-down resistor at the module, a lost supply or signal wire drops the reading to 0 V, while a lost ground can push it above 4.7 V, as a Denso patent on vehicle pressure sensors explains. Ratiometric transducers such as Honeywell's also drive power or ground loss to a defined rail. Sensor C usually sits in the brake module or hydraulic unit, and ABS, stability control or brake assist may be switched off.
Possible causes
- Loose, corroded or pushed-back pin at the sensor or module connector high
- Broken signal, supply or ground wire in the harness medium
- Internal open circuit in the pressure sensor low
Symptoms
- ABS, stability or brake warning lamp on
- Pressure value missing or fixed at a rail on the scan tool
- Fault may come and go when the connector is moved
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0573
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- patents.google.com/patent/US6657423B2/en
- prod-edam.honeywell.com/content/dam/honeywell-edam/sps/siot/ja/products/sensors/pressure-sensors/industrial-pressure-sensors/mip-series/documents/hon-ia-hss-mip-series-high-pressure-datasheet-en.pdf
- techtips.ie/Bosch/testing-for-a-brake-pressure-switch-fault.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2019/19OBDG03D Diagnostics.pdf