C0572
Brake Pressure Sensor C Circuit High
C0572 marks the upper end of the same sensor C channel: the pressure signal is at or above its top limit. GM's 2016–2019 hybrid brake modules check the signal voltage against the supply voltage and set the code when the two are practically equal for 0.1 s. The 2019 EBCM uses more than 95.24 % of supply voltage and explicitly includes an open signal line, so GM has no separate open-circuit code for this sensor. In the 2023 and 2025 tables the SENT master cylinder sensor reporting its maximum of 30,000 kPa for 0.96 s triggers it. All variants are Type A with MIL. A short to the reference voltage is the usual wiring cause; since the module would otherwise see heavy braking that is not happening, it stops trusting the sensor and limits brake functions.
Possible causes
- Signal line shorted to the 5 V reference or another supply high
- Open signal line pulled high by the module input (GM counts this here) medium
- Pressure sensor reporting full scale because of an internal fault medium
Symptoms
- Check engine light plus ABS or stability lamp (GM)
- Scan tool shows high brake pressure with the pedal released
- Brake assist and regenerative braking restricted
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C0572
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.