OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0570

Brake Booster Travel Sensor Circuit High

C0570 is the high-side counterpart of C056F: the booster travel signal reads above its plausible maximum. Typical triggers are a signal wire touching the 5 V reference line or battery positive, or a broken sensor ground that lets the input float upward. Travel sensing in boosters dates back to vacuum units in which an electrical sensor in the housing reported the position of the movable wall and had to be set against housing tolerances; electromechanical units like the iBooster measure pedal travel with a sensor inside the unit instead. No manufacturer documents C0570 publicly. A value stuck at the top can look like a fully pressed pedal, so the module normally disables electric assist and brake assist; stopping then needs much more pedal effort.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 70

Possible causes

  • Signal wire shorted to the 5 V reference or to battery voltage high
  • Open sensor ground letting the signal float to the upper limit medium
  • Travel sensor damaged internally, e.g. after water ingress at the booster medium
  • Wrong or not properly installed booster or sensor after a repair low

Symptoms

  • Electric brake assist switched off, pedal much harder
  • Brake warning and stability control lamp on
  • Driver assistance braking functions disabled

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0570

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication