C056F
Brake Booster Travel Sensor Circuit Low
The travel sensor tells the booster control how far its input side has moved. On older vacuum boosters it followed the movable wall; on Bosch's iBooster a differential travel sensor measures the offset between the pedal-driven input rod and the motor-driven booster body, and the controller works to bring that offset back to zero. C056F means the signal sits below its valid band – typically a short to ground, a lost sensor supply or an open reference. No maker publishes a C056F threshold; GM, for instance, files its pedal travel sensors as master cylinder piston position sensors (C05CC, C05CF). Without this input the module cuts or limits electric assist, so the pedal gets hard while the base brakes keep working.
Possible causes
- Travel sensor signal wire chafed through and shorted to ground high
- Missing 5 V supply to the sensor, e.g. corroded connector pin at the booster medium
- Internal fault of the travel sensor, usually built into the booster assembly medium
- Defective sensor input stage in the booster control unit low
Symptoms
- Hard brake pedal with clearly higher pedal force
- Brake system or stability warning lamp and a message to service the brakes
- Brake assist, automatic emergency braking or regenerative braking unavailable
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C056F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.