C056D
Brake Pedal Position Sensor Supply Voltage Circuit Low
The brake pedal angle sensor of a hybrid or brake-by-wire car is fed from a regulated 5 V line. C056D means this supply is present but sagging. Ford's 2015–2019 hybrid summaries set a joint window for C056D and C056E: if the supply leaves 4.87–5.13 V for 50 ms, the code for the low or high side is stored; in Ford's ABS module both appear as C100F and the hybrid powertrain module shows C056D for the low case. A drooping reference usually means a short to ground inside the sensor, a damaged supply wire or another load on the same rail. GM uses C056D in its own way, for example with parking brake faults on 2017–2019 Acadia, Traverse, Enclave and XT5 (PIT5662A).
Possible causes
- Pedal sensor loading the supply through an internal fault high
- Supply wire chafed to ground near the pedal box medium
- Another sensor on the same 5 V rail pulling it down medium
- Weak 5 V regulator in the brake module low
Symptoms
- Brake system warning and possibly stability lamp
- Regenerative braking reduced, firmer friction braking
- On GM models parking brake messages instead
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C056D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.