C056A
Brake Booster Pressure Sensor Power Supply Circuit
Pressure sensors in the brake system are ratiometric parts fed with 5 V from the control module; HELLA's booster vacuum sensor, for example, is specified for 4.5–5.5 V and answers with 0.5–4.5 V. If that supply is missing or out of range, every reading is wrong, so C056A is checked before the sensor signals are judged. Ford's 2015–2019 hybrids use C056A exactly this way: the missing-calibration and erratic checks of the brake pressure sensors (C0560, C056B) only run when no C056A supply fault is present. No maker publishes a C056A threshold. Bosch notes the booster vacuum signal also governs the electric vacuum pump and start/stop. Expect brake assist and stability functions to be limited.
Possible causes
- Open or shorted 5 V supply wire to the sensor high
- Another sensor on the same reference pulling the supply down medium
- Corroded sensor connector medium
- Faulty 5 V regulator in the control module low
Symptoms
- Brake or stability warning, often with further sensor codes
- Brake assist or electric vacuum pump control affected
- Stop/start inactive on some cars
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C056A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.