C0567
Brake Booster Solenoid Circuit Low
C0567 flags the brake booster solenoid circuit as too low – typically a short to ground on the line between the module's high-side driver and the coil. Ford describes the check in its 2015–2019 hybrid summaries: with both high-side and low-side drivers switched off, the module measures the voltage on the solenoid supply; below 3.0 V for 380 ms the fault is stored, and Ford's hybrid powertrain module shows it as C0567 (ABS module code C0022). Because a grounded line can overload the driver, the module stops using the solenoid. Brake assist from the booster then fails and hybrids lose part of the blended braking. Look for chafed harness near the booster or water in the connector before replacing the booster.
Possible causes
- Chafed solenoid wire shorting to body ground high
- Moisture or corrosion bridging the connector pins medium
- Shorted solenoid winding inside the booster low
Symptoms
- Brake system warning lamp
- No automatic brake assist
- Less regenerative braking on hybrids
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0567
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.