C0562
Brake Pedal Position Sensor Supply Voltage Circuit/Open
Hybrids, EVs and brake-by-wire cars measure how hard the driver wants to brake with a contactless pedal angle or travel sensor. Bosch builds these with a magnetic field sensor on a 5 V supply and two redundant outputs, often pulse-width modulated, so the module can cross-check them. C0562 reports that this 5 V feed is interrupted – the module sees no usable supply at all, unlike C056D (too low) and C056E (too high). No maker publishes a C0562 threshold; Ford's hybrids watch the same supply for a window of 4.87–5.13 V over 50 ms. Without the sensor the module cannot split braking between regeneration and friction, so regenerative braking and some assist functions are lost.
Possible causes
- Broken 5 V supply wire or pin pushed out at the pedal sensor high
- Sensor connector loose or left unplugged after pedal-area work medium
- Internal open circuit in the pedal sensor medium
- Brake module no longer providing the 5 V reference low
Symptoms
- Brake system or ABS warning lamp
- Regenerative braking reduced or off, pedal feel changes
- Brake lights or cruise control affected on some cars
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0562
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.