OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0561

Vacuum Sensor A/B Correlation

Where two vacuum signals describe the brake booster supply, the module expects them to track each other; C0561 means sensor A and sensor B disagree beyond the allowed band. No maker documents this code number publicly. The principle is patented: Ford compares the booster vacuum sensor with a second reservoir sensor after the vacuum pump stops and flags a sensor mismatch; GM checks the booster sensor against manifold vacuum at closed throttle and marks it biased high or low after set times. Sensors such as HELLA's run on 5 V and output 0.5–4.5 V. GM uses C0561 differently: in its brake modules it means stability control was disabled because another module reported a fault. Brake assist and stop/start may be limited.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 61

Possible causes

  • One vacuum sensor drifting or reading offset high
  • Leaking or kinked vacuum hose or check valve between the two measuring points medium
  • Corroded connector or damaged wiring on one sensor medium
  • Unstable 5 V reference or ground shared by the sensors low

Symptoms

  • Brake or stability warning lamp
  • Electric vacuum pump runs too often or not at all
  • Stop/start or brake assist unavailable on some cars

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for C0561

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication