OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0560

Brake Pressure Sensor A Missing Calibration

The brake module expects stored calibration data for pressure sensor A, normally the master cylinder pressure sensor: zero offset, sensor identity and a flag that the end-of-line or service calibration succeeded. C0560 means this data is absent or does not match the fitted sensor. GM's 2019 and 2025 tables check only the stored status, 500 ms after wake-up, Type A with MIL; GM's 2016 hybrid tables also call it when a test pulse reads above 110 % or below 90 %. Ford hybrids set it when checksum or sensor ID stored in sensor and module disagree (150 or 70 ms). Mitsubishi has a similar uncalibrated sensor code without SAE number (C105E-92). It typically follows a module or hydraulic unit swap; the scan tool calibration usually clears it.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 60

Possible causes

  • Pressure sensor calibration skipped after replacing the brake module or hydraulic unit high
  • Calibration interrupted, e.g. pedal touched or voltage dropped during the routine medium
  • Used or wrong hydraulic unit whose sensor data do not match the module medium
  • Non-volatile memory error in the brake module low

Symptoms

  • ABS, traction or stability lamp on after brake repair
  • Brake assist or stability functions unavailable
  • Check-engine lamp on some GM models

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0560

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication