OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C055F

BSCM/EBBC Hydraulic Unit Performance

The brake system control module (BSCM) or electronic brake boost controller (EBBC) has found that its hydraulic unit – master cylinder, pedal simulator, separation valves or boost plunger – does not perform as calculated. GM's 2019 tables test it during shutdown: a simulator leak sets C055F if secondary pressure drops under 15 bar; in 2025 a master cylinder leakage above 200 mm³/s also counts, Type A with MIL. On 2026 Silverado/Sierra 1500 GM replaces the master cylinder (PIT6450A); on 2022–26 trucks and SUVs the code appeared below −23 °C from low battery voltage (PIT6476). Jeep logs it as ABS Hydraulic Unit Performance on the 2021 Wrangler 4xe with MIL and fixes stored cases by ABS software (08-032-22). Expect a hard or changed pedal.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 5F

Possible causes

  • Internal leak or failure of the master cylinder or pedal simulator high
  • Low battery voltage, especially in severe cold, during the self-test medium
  • Brake module software flagging the unit too readily (update available) medium
  • Poor power or ground terminals at the brake module low

Symptoms

  • Service Brake System message, ABS and stability lamps
  • Hard pedal or changed brake pedal effort
  • Check-engine lamp on some models

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for C055F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication