OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C055D

Brake Hydraulic Circuit B Leak

Passenger-car brakes are split into two hydraulic circuits so that one can still stop the car if the other fails. Brake-by-wire units with a motor-driven plunger can estimate fluid loss directly: they compare the plunger travel with the measured pressure. In GM's 2025 EBCM tables C055D is the leak check of one circuit (listed as circuit 1): if the calculated leakage passes 500 mm³/s (a second stage 2000 mm³/s) for 0.1–0.5 s while braking with the circuits separated, a Type A fault with MIL is set after one trip. C055E covers the other circuit. FMVSS 135 requires a red brake warning when a split system suffers a major drop in fluid level or pressure. The car then brakes with reduced effect and longer pedal travel; it must be checked before further driving.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 5D

Possible causes

  • Leaking brake line, hose, fitting or caliper in this circuit high
  • Worn seal in the master cylinder or the brake-by-wire unit medium
  • Air left in the circuit after service, read as compliance or leakage medium
  • Overly sensitive leak calculation in the brake module software low

Symptoms

  • Red brake warning and amber ABS or stability lamp
  • Soft or sinking brake pedal, longer stopping distance
  • Falling fluid level or wet spots at a wheel

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C055D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication