C0557
Left Rear Wheel Speed Sensor A Incorrect Component Installed
C0557 concerns the speed sensor at the left rear wheel: its signal exists, but the ABS module judges the fitted part as not matching. Mitsubishi lists C1065-4A on the 2023 Outlander PHEV as C0557 (sensor in the wrong position, up to 3 s, MIL after two trips). Ford reports the same fault type with its base code plus failure byte, C0037:4A. On 2025 Bronco and Ranger, special service messages 53875 and 53988 (plus their Ranger counterparts) show it together with C003A:4A at start-up as an ABS software issue; replacing sensors or the module does not help, the fix is reprogramming the ABS module. So before buying a sensor, compare part numbers and look for software bulletins. Unlike C050C (circuit open) or C0510 (erratic), the wiring is usually fine here.
Possible causes
- ABS module software misjudges the sensor (fixed by reprogramming) medium
- Wrong or other-side sensor fitted at the left rear high
- Rear sensor connectors swapped left and right low
Symptoms
- Several brake system warnings at start-up
- ABS and stability control unavailable
- Check-engine lamp on some models
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0557
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.