C054F
Vacuum Sensor B Circuit Low
The voltage from vacuum sensor B is lower than any value its characteristic allows. Taking HELLA's booster sensor as the reference, the output should never drop below 0.4 V, while 0.5 V corresponds to no vacuum at all; a reading underneath that is electrical rather than physical. A signal line grounded through chafing, a lost 5-V supply or a sensor with a dead output stage are the usual sources, and a low supply (C0548) can contribute. Mitsubishi's brake unit shows that short circuits on the brake vacuum sensor are caught within one second. Bosch lists pump control and stop-start among the functions fed by this measurement, so they fall back when it is lost. No maker documents C054F publicly. C0550 is the high fault, C054B the low fault of sensor A.
Possible causes
- Signal wire of sensor B grounded high
- No 5-V feed at sensor B medium
- Output stage of sensor B failed low
Symptoms
- Brake assist warning shown
- Stop-start unavailable
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for C054F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.