C054C
Vacuum Sensor A Circuit High
Vacuum sensor A reports a voltage above its upper clamp. HELLA's booster sensor never exceeds 4.8 V when intact, even at full vacuum, so a higher reading indicates a signal shorted to the 5-V supply or to battery voltage, an open ground, or an internal defect. On a characteristic where more volts mean more vacuum, such a fault pretends a deep vacuum that may not exist; that is the riskier direction, because the electric pump could stay off. Brake units therefore check the circuit continuously; the 2023 Mitsubishi Outlander PHEV reports a shorted vacuum sensor circuit in at most one second and suspends brake assist. Bosch describes the sensor as the input for pump control and stop-start. No maker documents C054C publicly. C054B is the low counterpart, C0550 the same fault on sensor B.
Possible causes
- Signal line shorted to supply or battery voltage high
- Sensor ground interrupted medium
- Sensor failed with output stuck high low
Symptoms
- Brake assist warning on
- Harder brake pedal if the booster really runs short of vacuum
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for C054C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.