C054B
Vacuum Sensor A Circuit Low
The signal of vacuum sensor A has fallen below the lowest voltage a working sensor can produce. In HELLA's design the output runs from 0.5 V at no vacuum to 4.5 V at −1000 hPa and is clamped to a 0.4–4.8 V band, so anything under that floor must be electrical: a grounded signal line, an absent 5-V feed or an internally failed sensor. Because low voltage in such a characteristic means little or no vacuum, the brake control unit cannot trust the value and may run the electric pump as a precaution or block functions that depend on it, which Bosch names as pump control, stop-start and ESP assistance. Mitsubishi detects short circuits on its brake vacuum sensor within a second. No maker documents C054B publicly. C054C is the high counterpart.
Possible causes
- Signal wire shorted to ground high
- 5-V supply to the sensor missing medium
- Sensor failed with output stuck low low
Symptoms
- Brake assist or brake system warning lit
- Electric vacuum pump running continuously
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for C054B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.