C0548
Vacuum Sensor Supply Voltage Low
The supply reaching the vacuum sensor is present but sags below its lower limit. With a ratiometric sensor every output voltage scales with the feed, so an under-supplied sensor reports a wrong vacuum even if it is healthy. HELLA rates its brake booster vacuum sensor for 4.5 to 5.5 V and maps 0 to −1000 hPa onto 0.5 to 4.5 V; a feed near the bottom of that window already shifts the reading. On a Saab 9-5 the brake module reacts to a sensor supply under 4.4 V within 0.06 s. Typical causes are a weak module output, an extra load on a shared 5-V rail or high resistance in the feed wire. No maker documents C0548 publicly. C0547 covers an open or shorted supply, C054B and C054F low sensor signals.
Possible causes
- Another sensor on the same 5-V rail drawing it down high
- Corroded contact or damaged feed wire adding resistance medium
- Weak sensor supply output in the control module low
Symptoms
- Brake or ESC warning lamp on
- Vacuum reading implausible in live data
- Further codes for sensors on the same supply
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C0548
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.