OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0547

Vacuum Sensor Supply Voltage Circuit/Open

Fault in the feed circuit powering the vacuum sensor on the brake booster, usually an open or a short on the regulated supply. Such sensors need a stable 5 V: HELLA specifies 4.5 to 5.5 V for its three-pin vacuum sensor (output, ground, supply), whose analogue signal tells the brake control unit when to run the electric vacuum pump. Bosch describes the same sensor as the basis for pump control, stop-start and ESP assistance. A Saab 9-5 brake module shows how a supply is policed on a brake sensor: outside 4.4 to 5.6 V lasting 0.06 s is a fault. No maker documents C0547 publicly. Without valid supply the vacuum value is lost, so assist functions and an electric pump may run on fallback. C0548 is the narrower case of a supply that is merely too low.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 47

Possible causes

  • Supply wire or connector pin interrupted high
  • Supply line shorted to ground or another circuit medium
  • Vacuum sensor shorting the supply internally low

Symptoms

  • Brake system or ESC warning shown
  • Stop-start inactive or electric vacuum pump running constantly

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for C0547

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication