C0544
Brake Pressure Sensor B Circuit/Open
The brake module sees a general electrical fault in the circuit of pressure sensor B, usually an interruption in signal, feed or ground. No maker publishes this exact meaning; note that GM bulletins use C0544 for a different, steering-related fault in its power steering module, so a GM scan result must be read with GM definitions. For the component itself, Saab 9-5 (2011) data shows how such circuits are watched: the brake module watches both the sensor feed and its output line, sets a fault after 0.1 s of open or high resistance and disables ABS, traction and stability control for that ignition cycle. Bentley shows that sensor B can sit inside the ESC unit, which then has to be replaced as a whole. C0541 covers implausible values, C0542 and C0543 low and high voltage.
Possible causes
- Connector at sensor or brake module loose or corroded high
- Interrupted signal, feed or ground wire medium
- Open inside the sensor or the ESC unit carrying it low
Symptoms
- ABS, traction and stability warning lamps on
- Driver assistance relying on brake pressure unavailable
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0544
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2011/5-brakes/tcs-esp/fault-diagnosis-diagnostic-trouble-codes/dtc-c0131
- saabwisonline.com/9-5-9600/2010/5-brakes/stabiliser-system-esp/fault-diagnosis-diagnostic-trouble-codes/c0131
- static.nhtsa.gov/odi/tsbs/2021/MC-10201936-0001.pdf
- static.nhtsa.gov/odi/tsbs/2014/MC-10112002-9999.pdf