C0542
Brake Pressure Sensor B Circuit Low
Brake pressure sensor B pulls its signal below the lowest voltage the receiving module treats as valid. Two makers name the code in public bulletins. Bentley lists C054200 in the ESC unit J104 of the Continental GT/GTC and Flying Spur alongside C054100, with adaptive cruise switched off and the J104 replaced. Stellantis lists C0542 as Brake Pressure Sensor 2 Circuit Low among powertrain-module faults of the 2019 Jeep Cherokee with 3.2-litre V6 and engine stop-start; there a PCM software update was the remedy, with a check-engine lamp as the complaint. As a reference for the electrical limit, a Saab 9-5 brake unit treats anything under 0.25 V lasting 0.1 s as a sensor fault. Signal shorts to ground, a missing 5-V feed or a failed sensor are the usual causes.
Possible causes
- Signal line shorted to ground high
- Sensor or the ESC unit with integrated sensor defective medium
- Engine control software misjudging the signal (Jeep Cherokee 2019) medium
- 5-V sensor supply dragged down low
Symptoms
- Check-engine or ESC warning lamp on
- Adaptive cruise control or stop-start unavailable
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0542
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.