OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0540

Brake Pressure Sensor A Circuit/Open

General electrical fault in the circuit of brake pressure sensor A, typically an interrupted signal, reference or ground wire, or a connection with excessive resistance. No manufacturer documents this exact code publicly; Mitsubishi, for example, maps its sensor-A faults to C0044 and C053D to C053F instead. The function is well described elsewhere: a Bosch patent has the master-cylinder pressure sensor report to the ESC controller, which lights ABS and ESC lamps and changes to a reduced or off state on a fault, and Saab 9-5 (2011) service data checks the 5-V feed and the signal wire for opens within 0.1 s and then shuts off ABS, traction and stability control until the next ignition cycle. Ordinary braking remains. Low and high voltages have their own codes, C053E and C053F.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 40

Possible causes

  • Loose, corroded or pushed-out pin at the sensor or brake module connector high
  • Broken signal, reference or ground wire medium
  • Internal open circuit in the pressure sensor low

Symptoms

  • ABS and ESC warning lamps on
  • Stability and traction control out of service
  • Brake assist or hill-start assist missing

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0540

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication