OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C053F

Brake Pressure Sensor A Circuit High

Brake pressure sensor A reports a voltage above the upper limit of its valid band. Since the sensor is fed with 5 V, a short of the signal line to the reference or to battery voltage, a broken ground wire or an internal fault can push the reading up; a Saab 9-5 brake unit draws the line at 4.75 V lasting 0.1 s. GM-built Saab 9-5 models from 2011 check both the 5-V reference and the signal wire of the pressure sensor, which sits in the brake modulator valve block, and then disable ABS, traction and stability control for the ignition cycle. The only public code mapping comes from Mitsubishi: C106C-17 equals C053F on the 2023 Outlander PHEV, with ASC lamp and MIL after two trips and a detection delay of a second at most. C053E is the opposite fault.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 3F

Possible causes

  • Signal wire shorted to the 5-V reference or battery voltage high
  • Open or corroded sensor ground medium
  • Pressure sensor in the hydraulic unit defective medium

Symptoms

  • ABS and stability control warning lamps on
  • Traction control, stability control and hill-start assist unavailable
  • Check-engine lamp on some hybrids

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C053F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication