OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C053E

Brake Pressure Sensor A Circuit Low

The voltage on the signal line of brake pressure sensor A has dropped under the lower limit the brake module accepts. Such ratiometric 5-V sensors normally stay within a window: an older Saab 9-5 brake unit faults its pressure sensor below 0.25 V held for 0.1 s. Usual triggers are a signal wire shorted to ground, a lost 5-V feed or a sensor failing internally. GM shows a second pattern: on 2024 Silverado/Sierra 2500HD/3500HD, C053E with a MIL message at start-up came from the sensor still initializing and warming up; bulletin 24-NA-016 prescribes new EBCM software and warns against replacing the modulator valve. Mitsubishi lists C106C-16 as this code (Outlander PHEV 2023). Unlike C053F the reading is too low; unlike C053D it is electrically out of range.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 3E

Possible causes

  • Signal wire chafed through and touching ground high
  • Missing or weak 5-V reference to the sensor medium
  • Module software flagging the sensor during start-up warm-up (GM HD trucks 2024) medium
  • Pressure sensor failed internally low

Symptoms

  • ABS or stability control warning lamp lit
  • Message in the driver display right after start-up
  • Stability, traction control or brake assist switched off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C053E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication