C0533
Motor Control A Circuit Low
Motor control A reads low: an output that should be driven up stays close to ground. Typical reasons are chafed motor wiring touching the body, water in a connector or a failed low-side stage; a stalled motor drawing excess current can look similar to the driver. The J2012 title gives no motor, and no maker was found that documents C0533, so the A assignment remains vehicle-specific. In the Bosch patent US5329238 a terminal under the lower threshold during active drive indicates a short to minus; TI's DRV8873-Q1 handles shorts to ground through its overcurrent protection and can latch the affected half-bridge off. Because a ground short can draw high current, the module disables the motor and the associated function and sets its warning.
Possible causes
- Motor lead chafed through to body ground high
- Water ingress in the motor connector medium
- Low-side stage in the control unit failed low
Symptoms
- Warning lamp of the affected system on
- Motor A does not start; a fuse may blow
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0533
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.