C052E
ABS Pump Motor Control Circuit Low
Low counterpart of C052D: the pump motor control signal stays near ground when it should rise, pointing to a short to ground on the control side, a failed driver stage or a weak ground path of the hydraulic unit. No maker documents C052E publicly. In the Bosch patent US5329238 a terminal below the lower threshold is treated as a short to minus, and the drive is limited or switched off. Ford traced its older pump code C0020 on 2020 Explorer, Aviator and Police Interceptor Utility (bulletin 20-2364) to bad ground contact at G108, partly due to unsuitable bolt plating, and replaced the fasteners instead of the module, a reminder to check grounds first. While the code is active the pump cannot run on demand, so ABS and stability control are disabled.
Possible causes
- Poor ground connection of the ABS unit or hydraulic block high
- Control line or motor lead shorted to ground medium
- Driver stage in the ABS control unit failed medium
Symptoms
- ABS and ESC warning lamps on
- ABS and stability control unavailable
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C052E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.