C052D
ABS Pump Motor Control Circuit High
The pump motor control circuit reads higher than the commanded state allows, which normally means the control line or motor terminal is shorted toward battery voltage or the switching stage is stuck on. No manufacturer publishes this code; Mitsubishi, for example, reports its pump motor faults under C052B and C052C. The Bosch fault-monitoring patent US5329238 shows the principle: terminal voltages are compared with supply-referenced limits, a level above the upper one is taken as a short to plus, and the drive is then cut. With a stuck-on stage the pump may hum continuously and drain the 12 V battery. The US brake standard FMVSS 135 requires a warning for any electrical ABS failure; normal braking without ABS remains.
Possible causes
- Motor relay or semiconductor switch in the ABS unit stuck closed high
- Motor lead or control line shorted to battery voltage medium
- Moisture bridging pins in the ABS connector low
Symptoms
- ABS warning lamp on
- Pump motor runs continuously or hums with ignition on
- Battery discharged after standing
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for C052D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.