C0527
Steering Angle Sensor Module Mechanical
C0527 marks a mechanical rather than electrical fault of the steering angle sensor module. No manufacturer documents this code publicly. Many sensors are gear-driven: Bosch and Saab describe a hub gear on the steering shaft turning two measuring gears with different tooth counts (28 and 26 on the Saab 9-5), whose magnet positions encode the absolute angle. Broken teeth, a cracked housing, a worn drive dog or a sensor clipped in out of position make the reported angle stop following the wheel although supply and bus are fine. Bourns' contactless type checks its own angular speed and reports an error beyond 1016°/s, which a jumping gear would cause. Stability control is usually switched off; the cure is a new sensor and re-centring.
Possible causes
- Worn or broken measuring gears inside the sensor high
- Sensor drive dog or mounting loose on the steering shaft medium
- Sensor installed out of position after column or clock spring work medium
Symptoms
- ESC warning lamp on
- Angle on the scan tool jumps or stops changing while steering
- Possible noise from the steering column
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0527
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- bosch-mobility.com/en/solutions/sensors/steering-angle-sensor/
- saabwisonline.com/9-5-9600/2004/5-brakes/stabiliser-system-esp/technical-description/steering-wheel-angel-sensor
- bourns.com/data/global/pdfs/NC_Steering_Angle_Sensor_Type_6002.pdf
- saabwisonline.com/9-5-9650/2011/5-brakes/tcs-esp/adjustment-replacement/steering-wheel-position-sensor-replacement