OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0520

Multi-axis Acceleration Sensor Module A

General fault of module A without a narrower fault type. GM gives the most detail: in the 2023 and 2025 OBD tables of its Super Cruise controller (EOCM3), C0520 watches the high-performance IMU and sets when initialisation does not finish in time, the unit resets, its temperature status is invalid, offset or orientation learning is missing, or a swapped IMU is detected via its serial number. GM rates it Special Type C, emissions neutral, so no check-engine lamp; adaptive cruise and Super Cruise are switched off. Audi lists C052000 on the 2019 e-tron next to C051F00 for module A in the suspension control module. Compared with C051C to C051F, the code says only that the module as a whole failed.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 20

Possible causes

  • IMU fails to initialise in time or resets during operation medium
  • Module swapped, offset or orientation calibration not learned medium
  • Software fault in the module or the receiving controller medium
  • Internal electronic failure of module A low

Symptoms

  • ESC warning lamp or service message for stability control
  • Adaptive cruise or hands-free driving assistance unavailable (GM)
  • No check-engine lamp

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for C0520

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication