OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C051F

Multi-axis Acceleration Sensor Module A Correlation

The brake controller finds that module A's signals do not agree with a second source of the same motion. Audi uses this code on the e-tron: the ABS unit (address 0003) stores C051F00, and Audi's 2019 bulletin names the suspension control module as sensor module A. Waking the bus while the car falls asleep could set it, along with implausible lateral acceleration and yaw codes and a lost airbag-unit message; often an ignition cycle clears it, otherwise a drive above about 30 mph with the wheel turned 60 degrees each way. Bulletin 2061908 (2019 to 2024 e-tron and Q8 e-tron) logs it sporadically and fixes it with new ABS and suspension software. Bosch patents cross-check redundant inertial sensors the same way.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 1F

Possible causes

  • ABS or suspension control software fault (Audi e-tron update) high
  • Bus woken while modules enter sleep mode (door, charger) medium
  • Module A misaligned so its axes no longer match the reference low
  • Fault in the comparison source (second inertial sensor, steering angle, wheel speeds) low

Symptoms

  • ESC warning lamp and several cluster messages
  • Yellow drive fault message (Audi e-tron)
  • Fault often gone after the next ignition cycle

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C051F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication