C051E
Multi-axis Acceleration Sensor Module A Intermittent/Erratic
Module A's data arrive, but values jump, freeze briefly or vanish for short moments instead of changing smoothly. Modern units digitise yaw rate and accelerations inside the module and pass them on over a serial link: Bosch's SMI810 uses SafeSPI with 16-bit data, and a Hyundai/Kia design checks each value against the sensor's measuring range before sending it over CAN to the stability controller. Loose plugs, vibration or supply dips can therefore show up as erratic samples. No manufacturer publishes C051E, so limits are unknown. The intermittent label separates it from a steady implausible value (C051C) and from a disagreement with other signals (C051F). The ESC lamp may come and go between drives.
Possible causes
- Loose or corroded connector at module A high
- Brief supply or ground dropouts, weak battery medium
- Module not firmly fastened, picks up vibration medium
- Sporadic internal fault of the sensor electronics low
Symptoms
- ESC warning lamp comes and goes
- Stability control occasionally unavailable
- Jumping yaw or acceleration values in live data
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C051E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.