OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C051D

Multi-axis Acceleration Sensor Module A Missing Calibration

The module holds no valid zero point or mounting orientation, typically after it or the brake controller was replaced and the setup step was skipped. Corrections like these live in non-volatile memory: Kelsey-Hayes measures the offset of the whole assembly on a turning stand and adds the in-car tilt. GM's Saab 9-4x shows the workshop side: a new multi-axis module (called IMU in the programming tool) must first be configured, then the yaw sensor learned on level ground. On its Super Cruise controller GM files missing offset or orientation learning and a detected swap of the high-performance IMU under C0520 instead. No public source uses C051D itself. Stability control stays off until the learn is done.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 1D

Possible causes

  • Module A or brake control module replaced without configuration and yaw sensor learn high
  • Learn procedure aborted, e.g. vehicle not level or voltage dropped medium
  • Stored calibration lost after software update or module fault low

Symptoms

  • ESC warning lamp on right after a repair
  • Stability and traction control unavailable
  • Driver assistance such as adaptive cruise may be disabled

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C051D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication