C051A
Left Rear Wheel Speed Sensor - Mechanical
C051A names a mechanical fault at the left rear sensor. Like its siblings it is listed but not documented by any manufacturer, so the actual setting rule is unknown. At the rear axle the encoder sits in different places: inside the hub bearing seal on many cars, as HELLA describes for multipole rings, or on the axle shaft or hub of rigid axles. Ford special service messages show the rear-specific risks: on Ford's F-53 motorhome chassis of 2020, rear axle tone rings bent during hub and rotor installation, and on 2021–2022 F-150 trucks with a three-quarter floating axle, metal particles on axle tone rings and sensors set rear sensor codes until the axle tubes were cleaned. Those Ford cases were stored as C0037 and C0036, not as C051A.
Possible causes
- Rear tone ring bent or cracked, often after hub or brake work medium
- Metal particles or rust on the rear encoder or sensor tip high
- Left rear hub bearing worn, encoder seal damaged medium
Symptoms
- ABS lamp, sometimes only under load or on rough roads
- Rear wheel speed drops out or jitters in live data
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C051A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.