C0512
Right Rear Wheel Speed Sensor A Circuit/Open
C0512 is the open-circuit code for the right rear wheel. GM's 2016 hybrid tables run the check only after the sensor self-test has finished and system voltage is above 6.9 V; then 0.12 s with less than 3.8 mA flowing in the signal wire is enough for a Type A entry. The XT4 section of GM's 2019 tables words the same test as a ground short or interruption and monitors the supply line separately. Mitsubishi assigns C1067-13 to C0512 with a delay of at most one second and lists harness, sensor and the brake unit's power feed as suspects. Because an active sensor modulates a two-wire current, as Bosch describes it, a reading near zero cannot be a slow wheel; it points to a broken lead, an unplugged connector or a dead sensor.
Possible causes
- Broken lead or unplugged connector at the right rear high
- Right rear sensor open internally medium
- Fuse or power feed of the brake module (Mitsubishi lists it) low
Symptoms
- ABS and stability lamps on at key-on, sometimes the MIL
- Right rear wheel speed reads zero in live data
- ABS and traction control unavailable
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for C0512
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.