OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C050E

Left Rear Wheel Speed Sensor A Circuit Low

C050E reports the left rear sensor circuit pulled below its expected level. GM's 2019 EBCM tables (19OBDG03D) let the Polaris ASIC set it for three separate findings: an open sensor bit, a grounded low side, looked for only at start-up or once codes have been cleared, and sensor undervoltage, which needs only 20 ms; all are Type A with the MIL. The 2025 tables quantify the open-sensor bit as high-side current under 3.5 mA. Mitsubishi's C1065-11, its C050E, covers both short and open circuits and is one of the few wheel sensor faults there that also turns on the electric parking brake warning next to the ASC, ABS and engine lamps. A wire grounded against the rear subframe or a water-logged connector is the usual cause.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 0E

Possible causes

  • Sensor wire grounded against the subframe or body high
  • Moisture or corrosion in the left rear connector medium
  • Left rear sensor shorted internally medium
  • Low supply voltage at the brake module (fuse, battery) low

Symptoms

  • ABS, stability and electric parking brake warnings on (Mitsubishi)
  • ABS and stability control disabled for the rest of the trip

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for C050E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication