OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0509

Right Front Wheel Speed Sensor A Circuit High

C0509 means the right front sensor line carries more current or voltage than allowed. GM's 2019 tables (19OBDG03D) set it within 100 ms when the high-side current passes 40 mA, or when the Polaris ASIC reports either sensor line shorted to battery or an overcurrent on the low side; it is Type A. That limit sits well above anything a working sensor consumes, so a stuck reading there is a wiring or sensor fault, not a speed signal. Bosch describes its active sensors as working with a two-wire interface that follows an international standard and signals by current; there the brake module feeds the sensor and reads its pulses over the same pair, so one chafed spot affects both supply and signal. Mitsubishi assigns C1063-12, a short in the front right circuit, detected within 1 s and with MIL after one trip.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number5 / 09

Possible causes

  • Sensor line chafed against a battery-voltage wire high
  • Right front sensor drawing excess current due to an internal short medium
  • Sensor supply driver in the ABS module defective low

Symptoms

  • ABS and ESC lamps on immediately, check-engine lamp on some makes
  • ABS, EBD and hill start assist suspended

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for C0509

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication