OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0455

Steering Wheel Position Sensor Circuit

C0455 is absent from the accessible J2012 lists but well documented at GM, where the electronic brake control module (EBCM) stores it for the steering wheel position sensor circuit. Bulletin PI0639C, covering 2007–2016 full-size pickups, SUVs, vans and the Colorado/Canyon, blames rising resistance between sensor and EBCM caused by fretting corrosion and a connector with too much play; it says not to replace the sensor but to fit shim stock and apply dielectric grease. PIT4225F adds a steering wheel fitted off its master spline, and PIT5207 an EBCM programmed for the wrong sensor design on 2010 hybrids. The driver sees Service StabiliTrak, often together with C0710.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number4 / 55

Possible causes

  • Fretting corrosion and play at the sensor connector (GM PI0639C) high
  • Steering wheel not aligned with the shaft master spline medium
  • EBCM programmed for the wrong sensor design low
  • Steering wheel position sensor defective low

Symptoms

  • Service StabiliTrak message and stability lamp on
  • ABS lamp may come on first
  • Stability control unavailable

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0455

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication