OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Chassis generic / SAE

C0445

Steering Wheel Position Sensor Calibration

No accessible J2012 list contains C0445, and no manufacturer bulletin or service page using it could be found, so its exact meaning cannot be proven publicly. The title points to a steering wheel position sensor whose zero point was never learned or has been lost. Saab explains for the 9-5 that the sensor only knows straight ahead after a calibration, which is due after front-end work or a sensor swap. Mitsubishi resets both the sensor neutral point and the value stored in the stability unit after an alignment, and HELLA warns that a wrong zero upsets stability control. On the 2011 Saab 9-5, GM files this condition under C0710 symptom 42 instead. Expect the stability warning lamp and ESC out of action until the sensor is calibrated.

SystemChassis
Typegeneric / SAE
GroupC0
Range / number4 / 45

Possible causes

  • Zero-point calibration skipped after alignment, steering work or sensor replacement high
  • Stored calibration lost after battery disconnection or low voltage medium
  • Stability control module replaced or reprogrammed without relearning the angle low

Symptoms

  • ESC or traction control warning lamp on
  • Stability control unavailable
  • Steering wheel reading not zero when driving straight (scan tool)

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for C0445

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 1 warning for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication