C0440
Steering Wheel Position Sensor Circuit
C0440 cannot be verified publicly; searches of the available J2012 tables, GM bulletin PIP5094 and the full NHTSA index found no hit. Its title is word for word that of C0455, which GM does use for the steering wheel position sensor read by the brake module; the description here sticks to the sensor. It sits on the steering column and gives stability control the driver's intended direction. Bosch builds it with two measuring gears of different tooth counts, so the absolute angle is known over several turns, and sends angle and rate over CAN with internal plausibility checks. Saab's 9-5 sensor uses gears with 28 and 26 teeth and needs a zero calibration after front end work. GM bulletin PI0639D traces C0455 on 2007–17 trucks and vans to fretting corrosion at the connector.
Possible causes
- Fretting corrosion or loose fit at the sensor connector high
- Zero position not calibrated after alignment or column work medium
- Steering angle sensor internally defective low
Symptoms
- Stability control and traction control warning lamps on
- Service StabiliTrak or ESP message
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for C0440
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.